Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
10.1. Description of a design
10.2. Adjustment of the drive of switching off of coupling
10.3. Pumping of a hydraulic actuator of coupling
10.4. Removal of the main cylinder of a hydraulic actuator of coupling
10.5. Removal of a flexible hose of a hydraulic actuator of coupling
10.6. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the engine UEPA-331
10.7. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the VAZ-2106 engine
10.8. Replacement of a casing and the conducted clutch plate on the car with the engine UEPA-331
10.9. Replacement of a casing and the conducted clutch plate on the car with the VAZ-2106 engine
10:10. Removal of the mechanism of the drive of switching off of coupling on the car with the engine UEPA-331
10:11. Removal of the mechanism of the drive of switching off of coupling on the car with the VAZ-2106 engine
10:12. Councils of skilled
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










10-3-prokachka-gidroprivoda-scepleniya.html

10.3. Pumping of a hydraulic actuator of coupling

Coupling hydraulic actuators on cars with engines UEPA-331 and VAZ-2106 are pumped over similarly. We show work on the example of the engine UEPA-331. We install the car on the elevator or a viewing ditch. We check liquid level in a tank of a hydraulic actuator of coupling and if necessary we add liquid.

We remove a cap from the flowing union of the working cylinder.

We put on a transparent plastic hose which end is lowered in the container with brake fluid the union.

The assistant in interior of the car three-four times sharply presses a coupling pedal.

At the pressed pedal Rozhkov a key "on 8" we unscrew the union on 1/2-3/4 turns.

After liquid with vials of air comes out a hose, we wrap the union. We continue pumping until in liquid there are vials of air. Then at the pressed pedal of coupling we wrap the union, we remove a hose and we put on a cap.

Pumping over a coupling hydraulic actuator, do not allow lowering of the level of liquid in a tank below minimum admissible and if necessary add liquid. At a serviceable hydraulic actuator the full speed of a pusher of a fork at the pedal pressed against the stop has to be not less than 19 mm.


"previous page
10.2. Adjustment of the drive of switching off of coupling
following page"
10.4. Removal of the main cylinder of a hydraulic actuator of coupling