Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
10.1. Description of a design
10.2. Adjustment of the drive of switching off of coupling
10.3. Pumping of a hydraulic actuator of coupling
10.4. Removal of the main cylinder of a hydraulic actuator of coupling
10.5. Removal of a flexible hose of a hydraulic actuator of coupling
10.6. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the engine UEPA-331
10.7. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the VAZ-2106 engine
10.8. Replacement of a casing and the conducted clutch plate on the car with the engine UEPA-331
10.9. Replacement of a casing and the conducted clutch plate on the car with the VAZ-2106 engine
10:10. Removal of the mechanism of the drive of switching off of coupling on the car with the engine UEPA-331
10:11. Removal of the mechanism of the drive of switching off of coupling on the car with the VAZ-2106 engine
10:12. Councils of skilled
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










10-7-snyatie-rabochego-cilindra-gidroprivoda-scepleniya-na-avtomobile-s-dvigatelem-vaz-2106.html

10.7. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the VAZ-2106 engine

We perform work on a viewing ditch or the elevator.

We remove a returnable spring.

Passatizhami we take out the forelock from an opening in a pusher.

Cap key "on 13" we turn off two bolts of fastening of the working cylinder to a coupling case.

We take out bolts and we remove an arm of a returnable spring.

We bring a pusher out of a coupling switching off fork opening.

Holding a tip of a flexible hose from a provorachivaniye a key "on 17", we rotate the cylinder for an adapter hexagon a key of the same dimension...

... also we remove the cylinder.

Connection of a hose with an adapter is condensed with copper laying.

Holding the cylinder for a case stopper a key "on 22", we turn off an adapter a key "on 17"...

... also we separate the cylinder from an adapter.

We install the working cylinder in the return sequence. If at the same time the flexible hose of a hydraulic actuator was strongly overwound, we weaken connection of a hose with a metal tube of a hydraulic actuator and an eye of a body (see. "Removal of a flexible hose of a hydraulic actuator of coupling"), we turn a hose in the necessary situation and again we delay connections. We pump over a coupling hydraulic actuator (see. "Pumping of a hydraulic actuator of coupling").


"previous page
10.6. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the engine UEPA-331
following page"
10.8. Replacement of a casing and the conducted clutch plate on the car with the engine UEPA-331