Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
11.1. Description of a design
11.2. Oil replacement
11.3. Replacement of an epiploon of a secondary shaft
11.4. Removal of the drive of a speedometer
11.5. Removal and installation of the transmission on the car with the engine UEPA-331
11.6. Removal and installation of the transmission on the car with the VAZ-2106 engine
11.7. Replacement of an epiploon of a main shaft of the transmission on the car with the engine UEPA-331
11.8. Replacement of an epiploon of a main shaft of the transmission on the car with the VAZ-2106 engine
11.9. Replacement of the forward bearing of a main shaft of the transmission
11:10. Dismantling and assembly of the transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










11-3-zamena-salnika-vtorichnogo-vala.html

11.3. Replacement of an epiploon of a secondary shaft

We perform work on a viewing ditch or the elevator.

We remove cardan transfer and a sealant of shliyets of a shaft of the forward driveshaft from a nut of fastening of a flange of the elastic coupling (see. "Removal of cardan transfer").

By nippers it is unclenched a lock ring, we hook the screw-driver...

... also we remove it.

To small beards we unbend edges of a lock washer.

Key "on 30" we turn off a nut of fastening of a flange of the elastic coupling, pressing at the same time the aligning ring of a flange of the forward driveshaft. We hold a flange of the elastic coupling from a provorachivaniye an assembly shovel for hairpins.

We remove the aligning ring...

... nut of fastening of a flange...

... lock washer...

... and flange.

If removal of a flange is complicated, we press it a stripper.

Having hooked the screw-driver an epiploon of a secondary shaft...

... we take out it.

Having greased a working surface of an alnik with a thin layer of Litol-24 lubricant...

... we press it a tool head of the suitable size (a pipe piece).

We establish the dismantled details upside-down. We tighten a nut of fastening of a flange of the elastic coupling the ordered moment (see. "Appendix").

On a shaft of a secondary shaft of the transmission napressovyvay the aligning ring (see. "Removal of cardan transfer").


"previous page
11.2. Oil replacement
following page"
11.4. Removal of the drive of a speedometer