Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
12.1. Description of a design
12.2. Oil replacement
12.3. Replacement of an epiploon of a main shaft
12.4. Replacement of an epiploon of a secondary shaft
12.5. Removal of the drive of a speedometer
12.6. Removal of the transmission
12.7. Removal of the forward bearing of a main shaft of the transmission
12.8. Dismantling and assembly of the transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










12-3-zamena-salnika-pervichnogo-vala.html

12.3. Replacement of an epiploon of a main shaft

Work is carried out on a viewing ditch or the elevator. We remove the transmission (see. "Removal of the transmission").

Head "on 13" we turn off one nut in the lower part of the transmission...

... and a head "on 17" we turn off six more nuts.

We separate a coupling case from the transmission.

Having hooked an assembly shovel or the screw-driver an epiploon...

... we take it from a nest of the directing plug of the bearing of switching off of coupling installed in a coupling case.

Having greased a working surface of an epiploon with a thin layer of Litol-24 lubricant...

... we press it a suitable mandrel or a piece of a pipe with the outer diameter of 44 mm and internal not less than 35 mm.

At a press fitting do not damage a working edge of an epiploon (it is established by a spring towards the back bearing of a main shaft of the transmission).

Assembly is carried out in the return sequence, having replaced ullot-nitelny laying between cases of coupling and the transmission new and having greased it with a thin layer of silicone sealant.


"previous page
12.2. Oil replacement
following page"
12.4. Replacement of an epiploon of a secondary shaft