Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
13.1. Description of a design
13.2. Lubricant of shlitsevy connection of the driveshaft
13.3. Removal of cardan transfer
13.4. Replacement of an epiploon of shlitsevy connection of a flange of the elastic coupling and shaft of the forward driveshaft
13.5. Removal of the elastic coupling
13.6. Dismantling of the cardan hinge
13.7. Replacement of an intermediate support
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










13-7-zamena-promezhutochnojj-opory.html

13.7. Replacement of an intermediate support

We replace an intermediate support assembled with the bearing. We remove cardan transfer (see. "Removal of cardan transfer").

We mark a relative positioning of a forward shaft and forks of the hinge.

We disassemble the forward cardan hinge (see. "Dismantling of the cardan hinge").

Head "on 27" we turn off a nut of fastening of a fork to the forward driveshaft.

We remove a fork from shliyets of a shaft.

At difficulty - we press a stripper.

Cap key "on 12" we turn off two bolts of fastening of an arm to a support...

... also we remove an arm.

We remove a back mud-reflector.

We rest a shaft shaft against wooden whetstone.

Striking through a drift an internal metal edge of a support...

... we force down from a shaft a support assembled with the bearing.

We put on a shaft a new support assembled with the bearing and a gryazeotra-zhatel (the convex party to the bearing).

We establish a fork on a shaft on tags.

The face head of suitable diameter (or a pipe piece), leaning on a fork, napressovyvay a support assembled with the bearing on a shaft.

We fix an arm to a support. Having screwed a new nut of fastening of a fork to the forward driveshaft, we tighten it the ordered moment (see. "Appendix").

For latching of a nut to small beards we rebuff its fillet in a shaft shaft groove.


"previous page
13.6. Dismantling of the cardan hinge
following page"
14. Zadny Bridge