Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
15.1. Description of a design
15.2. Angles of installation of forward wheels
15.3. Removal of a spherical support
15.4. Removal of the lever
15.5. Removal of the stabilizer of cross stability
15.6. Removal of the directing spring rack
15.7. Replacement of the hug bearing
15.8. Removal of a stretcher
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










15-4-snyatie-rychaga.html

15.4. Removal of the lever

We remove the lever of a forward suspension bracket from the car for replacement of the saylent-block or the lever. The rubber and plastic plugs of a bar of the stabilizer installed in a lever eye can be replaced on the car, without removing the lever (see. "Removal of the stabilizer of cross stability").

For replacement of the lever we install the car on a viewing ditch or the elevator, we hang out its forward part and we remove a wheel.

We disconnect a spherical support from the lever (see. "Removal of a spherical support").

Passatizhami rasshplintovyvay a koronchaty nut of fastening of a bar of the stabilizer to the lever.

Cap key "on 24" we turn off a nut.

We remove a washer...

... and rubber plug.

Cap key "on 19" we turn off a nut of a bolt of fastening of the lever to a stretcher arm, holding a bolt from a provorachivaniye a cap key "on 17".

We beat out a bolt, striking blows with the hammer to a drift from soft metal.

We take out a bolt and we bring the lever out of an arm.

We remove the lever from the car.

Replacement of the plastic plug of the bar of the stabilizer established in a lever eye is shown in the subsection "Removal of the Stabilizer of Cross Stability".

Saylent-blok the lever we press off in a vice suitable pieces of pipes.

New saylent-block is moistened with soap solution and we press in the lever.

We install the lever on the car in the return sequence. Finally we tighten nuts of fastening of the lever to an arm of a stretcher and a bar of the stabilizer in situation "the car on wheels".


"previous page
15.3. Removal of a spherical support
following page"
15.5. Removal of the stabilizer of cross stability