Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
15.1. Description of a design
15.2. Angles of installation of forward wheels
15.3. Removal of a spherical support
15.4. Removal of the lever
15.5. Removal of the stabilizer of cross stability
15.6. Removal of the directing spring rack
15.7. Replacement of the hug bearing
15.8. Removal of a stretcher
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










15-7-zamena-podshipnika-stupicy.html

15.7. Replacement of the hug bearing

We perform work on a viewing ditch or the elevator.

We hang out and remove a wheel.

We disconnect a support from a guide of blocks (see. "Dismantling of the forward brake mechanism")...

... also we tie up them a wire to a suspension bracket spring.

We remove a brake disk (see. "Dismantling of the forward brake mechanism").

To small beards raskoktrivay hug bearing nut...

... and a head "on 32" we turn off a nut.

Under a nut the persistent washer is located.

We remove a nave together with the bearing from a pin of a rotary fist.

If the nave is not removed, it is possible to use a trekhza-hvatny stripper.

Happens that after removal of a nave on a pin there is an internal ring of the bearing. We move it a chisel and we shift from a pin two assembly shovels. If on a pin there were traces from a chisel, eliminate them with a file.

From a pro-point from the inside of a nave by nippers it is taken out a persistent ring of the bearing.

The hug bearing is removed only for replacement therefore...

... having put a nave inside on sponges of a vice, we beat out the bearing the hammer through a suitable piece of a pipe.

It is possible to Vypressovat the bearing also the stripper applied when replacing stupichny bearings on front-wheel cars VAZ. At the same time the stripper bolt through a washer has to rest against an internal ring of the bearing.

Stripper and bearing.

We take out the bearing from a nave.

Before installation of the new bearing we clear an internal surface of a nave and we grease Litolom-24.

We press the new bearing in a vice a suitable piece of a pipe or an external ring of the old bearing.

For a press fitting it is possible to use a stripper, leaning its cup on a nave surface, and a washer - only on an external ring of the bearing.

We insert a persistent ring into a nave pro-point and we install a nave on the car in the return sequence.

Do not forget to besiege a nut fillet in a groove of a pin of a rotary fist.


"previous page
15.6. Removal of the directing spring rack
following page"
15.8. Removal of a stretcher