Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
16.1. Description of a design
16.2. Removal of the shock-absorber
16.3. Removal of a spring
16.4. Removal of the top bar
16.5. Removal of the lower bar
16.6. Removal of a cross bar
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










16-5-snyatie-nizhnejj-shtangi.html

16.5. Removal of the lower bar

We perform work on a viewing ditch or the elevator.

The screw-driver we unbend a uvula of an arm of fastening of a cable of the parking brake to the lower bar...

... also we remove a bracket of fastening of a cable.

Cap key "on 19" we turn off a nut of a bolt of fastening of a bar to an arm of a beam of the back bridge, holding a bolt from a provorachivaniye a key "on 17".

Through a drift from soft metal we beat out a bolt...

... also we take out it.

We bring a bar out of an arm on a beam of the back bridge.

Cap key "on 19" we turn off a nut of a bolt of fastening of a bar to an arm on a body longeron, holding a bolt from a provorachivaniye a key "on 17".

We beat out a bolt through a drift from soft metal.

We take out a bolt and we remove a bar.

For replacement of rubber plugs of a bar we clamp it with small effort in a vice.

Stripper we press off the plug in the cup leaning on edges of an eye....

... also we take out rubber and steel (expansion) plugs.

We grease the new rubber plug with soap solution...

... also we press in an eye in a vice.

For a press fitting of the expansion plug...

... we use a conic mandrel or a tool head with different outer diameters.

We insert a mandrel into the opening of the rubber plug greased with soap solution...

... and in a vice we press the expansion plug.

We establish a bar in the return sequence. Nuts of bolts of fastening are finally tightened in situation "the car on wheels".


"previous page
16.4. Removal of the top bar
following page"
16.6. Removal of a cross bar