Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
17.1. Description of a design
17.2. Adjustment of the steering mechanism
17.3. Removal of a steering wheel
17.4. Removal of a steering column
17.5. Removal of the lower cardan hinge
17.6. Removal of an external tip of steering draft
17.7. Replacement of a cover of a lath
17.8. Removal of the steering mechanism
17.9. Dismantling of the steering mechanism
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










17-3-snyatie-rulevogo-kolesa.html

17.3. Removal of a steering wheel

We perform work for removal of the understeering switch, a steering column, when replacing a contact ring of a sound signal or most steering wheel.

Sometimes it is necessary to reinstall a steering wheel after adjustment of angles of installation of wheels of the car.

We disconnect a wire of "weight" from the rechargeable battery. Having taken out a key from the ignition lock, we turn a steering wheel, the device locking a steering shaft will not work yet. We mark chalk a peak of the dashboard and a steering wheel.

We hook the screw-driver an overlay of a cover of the switch of a signal...

... also we remove it.

By the crosswise screw-driver it is turned off two self-tapping screws...

... also we uncover.

Head "on 24" with the extender to otvorachiva a nut of fastening of a steering wheel, but not up to the end.

Shaking, we pull on ourselves a steering wheel. If it moved on shaft vents...

... we turn off up to the end a nut of fastening and we remove a steering wheel.

If in such a way it is not possible to shift a steering wheel...

... we strike with the hammer through a drift from soft metal blows to an end face of a steering shaft, at the same time the assistant has to pull together a steering wheel from a shaft.

We establish a steering wheel in the return sequence on the put tags. When replacing by similar we combine two wheels and we transfer a tag to new.

If the provision of a steering wheel on a shaft did not coincide with former and spokes of a steering wheel at the movement of the car on a straight line settle down asymmetrically, in this situation we stop the car, we remove a steering wheel and we put it correctly then again we check installation accuracy. Work is carried out on the horizontal flat platform.


"previous page
17.2. Adjustment of the steering mechanism
following page"
17.4. Removal of a steering column