Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
17.1. Description of a design
17.2. Adjustment of the steering mechanism
17.3. Removal of a steering wheel
17.4. Removal of a steering column
17.5. Removal of the lower cardan hinge
17.6. Removal of an external tip of steering draft
17.7. Replacement of a cover of a lath
17.8. Removal of the steering mechanism
17.9. Dismantling of the steering mechanism
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










17-4-snyatie-rulevojj-kolonki.html

17.4. Removal of a steering column

We remove a steering wheel (see. "Removal of a steering wheel"). We remove casings of a steering column (see. "Understeering switch"). We remove the ignition switch (see. "Removal of the switch of ignition").

Cap key "on 17" we turn off four nuts of fastening of a steering column to an arm of pedal knot (the lower part of the dashboard is for descriptive reasons removed)...

... also we lower a shaft.

Under the lower collar of fastening there is a rubber laying.

In a motor compartment under the main brake cylinder the rubber cover is shifted up a shaft, we turn off a bolt of fastening and we weaken terminal connection of an intermediate shaft with the lower cardan hinge (see. "Removal of the lower cardan hinge"). We moisten an intermediate shaft with the getting lubricant of the WD-40 type. that it easier left an opening of a rubber boot and a sealant in a motor board.

Having pulled, we take out a shaft from shlits of the lower cardan hinge and we extend it through a rubber sealant in salon.

We remove a rubber cover from the lower cardan hinge.

Pay attention: on a shlitsevy part of an intermediate shaft the platform which at assembly of connection has to coincide with a cut in the lower cardan hinge is executed.

We establish a steering column in the return sequence.


"previous page
17.3. Removal of a steering wheel
following page"
17.5. Removal of the lower cardan hinge