Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
17.1. Description of a design
17.2. Adjustment of the steering mechanism
17.3. Removal of a steering wheel
17.4. Removal of a steering column
17.5. Removal of the lower cardan hinge
17.6. Removal of an external tip of steering draft
17.7. Replacement of a cover of a lath
17.8. Removal of the steering mechanism
17.9. Dismantling of the steering mechanism
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










17-5-snyatie-nizhnego-kardannogo-sharnira.html

17.5. Removal of the lower cardan hinge

The lower cardan hinge is removed at its wear or breakage, and also for replacement of a rubber cover. In a motor compartment under the main brake cylinder the rubber cover is shifted up a shaft...

... and a key "on 13" we turn off a nut of a bolt of fastening of the lower cardan hinge to an intermediate shaft, holding a bolt from a provorachivaniye a key "on 12".

We take out a bolt.

Similarly we dismantle a bolt of fastening of the lower cardan hinge to a shaft of a gear wheel of the steering mechanism.

By the Shlitsevy screw-driver it is weakened terminal connections of the lower cardan hinge with a shaft of a gear wheel of the steering mechanism...

... and with an intermediate shaft.

We shift the lower cardan hinge up vents before separation with a shaft of a gear wheel of the steering mechanism...

... also we remove it from shlits of an intermediate shaft (the rubber cover on a photo 5 and 6 is for descriptive reasons removed).

We install the new lower cardan hinge and a rubber cover in the return sequence. At the same time we collect the top connection, as shown in the head "Removal of a steering column" (a photo 6). We collect the lower connection randomly, however at the same time reinstallation of a steering wheel will be required (see. "Removal of a steering wheel").


"previous page
17.4. Removal of a steering column
following page"
17.6. Removal of an external tip of steering draft