Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
18.1. Description of a design
18.2. Pumping of brakes
18.3. Replacement of front brake shoes
18.4. Replacement of back brake shoes
18.5. Removal of the main brake cylinder
18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake
18.7. Removal of pedal knot
18.8. Removal of the signaling device
18.9. Removal of a forward brake hose
18:10. Dismantling of the forward brake mechanism
18:11. Replacement of the back wheel cylinder
18:12. Removal of a back brake hose
18:13. Check of working capacity and adjustment of the drive of the regulator of pressure of back brakes
18:14. Removal of the regulator of pressure of back brakes and its drive
18:15. Adjustment and removal of knots of the parking brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










18-3-zamena-perednikh-tormoznykh-kolodok.html

18.3. Replacement of front brake shoes

We hang out and remove a forward wheel.

Chisel we unbend edges of a lock plate of the lower bolt of fastening of a support with the cylinder to the directing finger.

Cap key "on 13" we turn off the lower bolt.

On an ear of the brake cylinder the fillet interfering a provorachivaniye of a hexagon of the directing finger is executed. If the finger is turned...

... we hold it the screw-driver, having inserted it between a hexagon and a fillet.

We take out a bolt with a lock plate.

By assembly shovel it is hooked and we raise a support...

... turning it with the cylinder around an axis of the top directing finger.

We take out brake shoes.

Before installation of new blocks it is necessary to drown the piston in the brake cylinder.

For this purpose it is possible to use sliding passatizha (and also a big clamp, an alligator wrench)...

... or an assembly shovel, having implanted it into a support window between the piston and a brake disk.

We establish brake shoes in the return sequence. Do not forget to zakontrit a bolt of fastening of a support with the cylinder to the directing finger, and before departure press several times a brake pedal to bring blocks to a disk.


"previous page
18.2. Pumping of brakes
following page"
18.4. Replacement of back brake shoes