Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
18.1. Description of a design
18.2. Pumping of brakes
18.3. Replacement of front brake shoes
18.4. Replacement of back brake shoes
18.5. Removal of the main brake cylinder
18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake
18.7. Removal of pedal knot
18.8. Removal of the signaling device
18.9. Removal of a forward brake hose
18:10. Dismantling of the forward brake mechanism
18:11. Replacement of the back wheel cylinder
18:12. Removal of a back brake hose
18:13. Check of working capacity and adjustment of the drive of the regulator of pressure of back brakes
18:14. Removal of the regulator of pressure of back brakes and its drive
18:15. Adjustment and removal of knots of the parking brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










18-6-snyatie-vakuumnogo-usilitelya-tormozov-i-regulirovka-svobodnogo-khoda-pedali-tormoza.html

18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake

We remove the main brake cylinder (see. "Removal of the main brake cylinder").

Having hooked the screw-driver...

... we take out the backpressure valve from the case of the amplifier...

... and its rubber sealant.

In salon of a passatizhama rasshplintovyvay piston pusher fork finger...

... we take out the forelock...

... and finger.

Also in salon by a head "on 13" with the extender it is turned off four nuts of fastening of the vacuum amplifier and pedal knot to a body front guard.

We bring a pusher of the amplifier out of an opening of a guard of a front and we take the vacuum amplifier from a motor compartment.

We establish the vacuum amplifier of brakes in the return sequence. At installation of the backpressure valve we moisten it and a sealant with the getting liquid of the WD-40 type. Before installation of the main brake cylinder...

... we control vystupany heads of its adjusting bolt concerning the plane of fastening of a flange of the main brake cylinder which has to make 1,25-0,2 mm.

For adjustment of a vystupaniye of a head of a bolt we rotate it a key "on 8".

For removal of the switch of a stoplight...

... we disconnect from it wires.

Having weakened a lock-nut a key "on 19". a key "on 14" we turn out the stoplight switch from an arm of pedal knot...

... also we take out the switch.

We install the stoplight switch in the return sequence and we regulate its situation, rotating the switch case in an arm (at the disconnected wires). The switch of a stoplight is installed so that its button concerned a pedal emphasis at a free wheeling of a pedal of a brake of 3-5 mm. In this situation we tighten a lock-nut.


"previous page
18.5. Removal of the main brake cylinder
following page"
18.7. Removal of pedal knot