Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
18.1. Description of a design
18.2. Pumping of brakes
18.3. Replacement of front brake shoes
18.4. Replacement of back brake shoes
18.5. Removal of the main brake cylinder
18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake
18.7. Removal of pedal knot
18.8. Removal of the signaling device
18.9. Removal of a forward brake hose
18:10. Dismantling of the forward brake mechanism
18:11. Replacement of the back wheel cylinder
18:12. Removal of a back brake hose
18:13. Check of working capacity and adjustment of the drive of the regulator of pressure of back brakes
18:14. Removal of the regulator of pressure of back brakes and its drive
18:15. Adjustment and removal of knots of the parking brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










18-7-snyatie-pedalnogo-uzla.html

18.7. Removal of pedal knot

The pedal knot is removed in case of deformation of pedals or their arm, and also for replacement of worn-out plastic plugs and the broken returnable springs.

We remove a steering column (see. "Removal of a steering column").

We disconnect a fork of a pusher of the main cylinder of coupling from a pedal and we turn off two nuts of fastening of the cylinder to pedal knot (see. "Removal of the main cylinder of a hydraulic actuator of coupling"). We disconnect a fork of a pusher of the vacuum amplifier from a pedal and we turn off four nuts of his fastening to pedal knot, and also we remove wires from the stoplight switch (see. "Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake").

By head "on 13" with the extender it is turned off two nuts of the top fastening of pedal knot to a body...

... also we remove pedal knot assembled.

Holding a head "on 17" a coupling pedal bolt axis from a provorachivaniye, a key of the same dimension we turn off a nut...

... also we take out a bolt axis.

We take out a pedal, its plastic plugs and a spring from an arm. Similarly we remove a brake pedal.

Details of pedal knot.

Before assembly we apply lubricant like Litol-24 on plugs of pedals, the ends of springs and a junction of pushers with pedals. We establish pedal knot in the return sequence.


"previous page
18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake
following page"
18.8. Removal of the signaling device