Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
21.1. Description of a design
21.2. Removal of the crane of a heater
21.3. Removal of the airsupercharger and fan of a heater
21.4. Removal of the additional resistor of the fan of a heater
21.5. Removal of a radiator of a heater
21.6. Removal of the case of a heater, control unit of a heater and air ducts of the dashboard
21.7. Removal of an air duct of air supply in a back part of salon
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










21-3-snyatie-vozdukhonagnetatelya-i-ventilyatora-otopitelya.html

21.3. Removal of the airsupercharger and fan of a heater

The airsupercharger is removed for access to fastening of the dashboard or for replacement of the fan of a heater.

We disconnect a wire of "weight" from the rechargeable battery.

We remove a sealant of a motor compartment from an otbortovka of the airsupercharger.

By the crosswise screw-driver it is turned off three self-tapping screws of fastening of an extension of the airsupercharger to a body...

... and one self-tapping screw connecting an extension and the airsupercharger.

We remove an extension of the airsupercharger.

Head "on 10" we turn off a nut of fastening of the airsupercharger to the right mudguard...

... and a fastening nut to a motor board.

We remove a wire of "mass" of the fan of a heater from a hairpin.

We raise air the supercharger...

... also we separate the socket of a "plus" wire of the fan of a heater.

Head "on 10" we unscrew two self-tapping screws of fastening of a casing of the fan to the case of the airsupercharger.

One self-tapping screw connects two wires of "weight".

By the Shpitsevy screw-driver it is disconnected four latches...

... and, having separated parts of the case of the airsupercharger...

... we take out the fan in a casing.

We remove a porolonovy sealant.

Having hooked the latch screw-driver...

... we separate parts of a casing of the fan.

Having disconnected fastening brackets...

... we uncover the fan electric motor...

... also we take the electric motor assembled with a krylchatka.

Assembly and installation of the fan and airsupercharger is carried out in the return sequence.

We paste a new porolonovy sealant of a casing of the fan.


"previous page
21.2. Removal of the crane of a heater
following page"
21.4. Removal of the additional resistor of the fan of a heater