Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
21.1. Description of a design
21.2. Removal of the crane of a heater
21.3. Removal of the airsupercharger and fan of a heater
21.4. Removal of the additional resistor of the fan of a heater
21.5. Removal of a radiator of a heater
21.6. Removal of the case of a heater, control unit of a heater and air ducts of the dashboard
21.7. Removal of an air duct of air supply in a back part of salon
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










21-6-snyatie-korpusa-otopitelya-bloka-upravleniya-otopitelem-i-vozdukhovodov-paneli-priborov.html

21.6. Removal of the case of a heater, control unit of a heater and air ducts of the dashboard

The case of a heater is removed for replacement at its deformation, damage of gates and leakage of connections of air ducts.

We remove the dashboard (see. "Removal of the dashboard").

The Shlitsevy screw-driver we hook a bracket of fastening of a cover of draft of control of the top gate...

... also we remove a bracket.

The crosswise screw-driver we unscrew the self-tapping screw of fastening of thirst for the top gate.

The bracket of fastening of a cover of draft of control of the lower gate is removed similarly...

... and we shift draft the screw-driver from the probe of the lever of the lower gate.

We remove the control unit of a heater with drafts.

Drafts are disconnected from the control unit of a heater similarly.

For removal of the case of a heater we disconnect hoses from a heater radiator (see. "Removal of a radiator of a heater").

Head "on 10" we turn off four nuts of fastening of the case of a heater to a body.

We remove the case of an otolitel from hairpins and we take out it.

We release fastening of a radiator (see. "Removal of a radiator of a heater")...

... also we take out a radiator from the case.

By the Shlitsevy screw-driver it is hooked eight brackets connecting parts of the case of an otolitel.

We separate the heater case.

For removal of air ducts on the dismantled dashboard...

... the crosswise screw-driver we unscrew the self-tapping screw of fastening of the left side air duct to the central air duct.

We remove the left side air duct.

By the crosswise screw-driver it is turned off four self-tapping screws of fastening of the right arm to the dashboard.

Similarly we disconnect the left arm.

We remove central and right side air ducts from the dashboard...

... also we exempt them from arms.

At installation of the case of a heater and air ducts of the dashboard porolonovy a sealant we replace new.


"previous page
21.5. Removal of a radiator of a heater
following page"
21.7. Removal of an air duct of air supply in a back part of salon