Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
5.1. Description of a design
5.2. Replacement of the fuel filter of thin cleaning
5.3. Replacement of a replaceable element of the air filter
5.4. Removal of the case of the air filter
5.5. Removal of the fuel pump on the car with the engine UEPA-331
5.6. Removal of the fuel pump on the car with the VAZ-2106 engine
5.7. Dismantling of the fuel pump
5.8. Removal of the fuel tank and fuel receiver
5.9. Removal of a cable of the drive of butterfly valves of the carburetor
5.10. Removal of a cable of the drive of the air gate of the carburetor
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










5-10-snyatie-trosa-privoda-vozdushnojj-zaslonki-karbyuratora.html

5.10. Removal of a cable of the drive of the air gate of the carburetor

We remove the case of the air filter (see. "Removal of the case of the air filter").

Holding a key "on 7" a lug of the lever of the drive of the air gate of the carburetor, the shlitsevy screw-driver we unscrew the screw fixing a cable.

Key "on 8" we weaken a bolt of fastening of the level holding a cable cover.

We take out a cable from an opening in a lever lug.

In salon by the crosswise screw-driver it is turned off two self-tapping screws of fastening of the panel of the control unit to the lower part of the dashboard.

Having turned the panel, by passatizha it is hooked a locking bracket of a tip of a cable.

We remove a locking bracket.

We stretch a cable through openings of a body and the panel of the control unit.

We remove a cable.

We establish a cable in the return sequence. At completely "drowned" handle the air gate has to be completely open. If necessary we adjust the drive movement of a cable at the weakened screw of its fastening.


"previous page
5.9. Removal of a cable of the drive of butterfly valves of the carburetor
following page"
6. Carburetor