Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
5.1. Description of a design
5.2. Replacement of the fuel filter of thin cleaning
5.3. Replacement of a replaceable element of the air filter
5.4. Removal of the case of the air filter
5.5. Removal of the fuel pump on the car with the engine UEPA-331
5.6. Removal of the fuel pump on the car with the VAZ-2106 engine
5.7. Dismantling of the fuel pump
5.8. Removal of the fuel tank and fuel receiver
5.9. Removal of a cable of the drive of butterfly valves of the carburetor
5.10. Removal of a cable of the drive of the air gate of the carburetor
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










5-5-snyatie-toplivnogo-nasosa-na-avtomobile-s-dvigatelem-umpo-331.html

5.5. Removal of the fuel pump on the car with the engine UEPA-331

We remove the case of the air filter (see. "Removal of the case of the air filter").

Passatizhami we weaken a collar of fastening of a fuel hose to the soaking-up branch pipe of the fuel pump...

... also we remove a hose from a branch pipe.

Similarly we weaken a collar and we disconnect the hose connecting a gasoline pump and the carburetor from the forcing branch pipe.

Key "on 12" we turn off two high nuts of hairpins of fastening of the pump to a head of the block of cylinders of the engine.

We remove the pump from hairpins.

For replacement of laying or a heat-insulating pro-rate...

... we remove laying and a pro-rate from hairpins.

We take a pusher.

We clear the privalochny plane of a head of the block of cylinders of dirt and the remains of old laying. We establish a heat-insulating pro-rate with external and internal laying. We insert a pusher and we check its vystupaniye over the plane of external laying, slowly turning a bent shaft of the engine and pressing a pusher a finger. The minimum size of a vystupaniye of a pusher has to make 1,0-1,5 mm.

We measure by a caliper a pusher vystupaniye.

If necessary we regulate a pusher vystupaniye selection of laying of different thickness.

We install the fuel pump in the return sequence.


"previous page
5.4. Removal of the case of the air filter
following page"
5.6. Removal of the fuel pump on the car with the VAZ-2106 engine