Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
5.1. Description of a design
5.2. Replacement of the fuel filter of thin cleaning
5.3. Replacement of a replaceable element of the air filter
5.4. Removal of the case of the air filter
5.5. Removal of the fuel pump on the car with the engine UEPA-331
5.6. Removal of the fuel pump on the car with the VAZ-2106 engine
5.7. Dismantling of the fuel pump
5.8. Removal of the fuel tank and fuel receiver
5.9. Removal of a cable of the drive of butterfly valves of the carburetor
5.10. Removal of a cable of the drive of the air gate of the carburetor
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










5-6-snyatie-toplivnogo-nasosa-na-avtomobile-s-dvigatelem-vaz-2106.html

5.6. Removal of the fuel pump on the car with the VAZ-2106 engine

We weaken collars of fastening of fuel hoses to branch pipes of the fuel pump...

... also we remove hoses from branch pipes.

Head "on 13" we turn off two nuts of hairpins of fastening of the pump to the block of cylinders of the engine.

We remove the pump from hairpins.

For replacement of laying or a heat-insulating pro-rate...

... we remove external laying.

We take a pusher.

We take out a heat-insulating pro-rate.

We remove one more sealing laying.

We clear the privalenny plane of the block of cylinders of dirt and the remains of old laying. We establish a pro-rate with laying (between a pro-rate and the block of cylinders) 0,27-0,33 mm thick. Outside of a pro-rate we establish laying 0,7-0,8 mm thick. We insert a pusher and we check its vystupaniye over the plane of external laying, slowly turning a bent shaft of the engine and pressing a pusher a finger. The minimum size of a height of an upaniye of a pusher has to make 1,0-1,5 mm.

We measure by a caliper a pusher vystupaniye.

If necessary we regulate a pusher vystupaniye selection of thickness of external laying (0,27-0,33 mm or 1,1-1,3 mm).

We install the fuel pump in the return sequence.


"previous page
5.5. Removal of the fuel pump on the car with the engine UEPA-331
following page"
5.7. Dismantling of the fuel pump