Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
5.1. Description of a design
5.2. Replacement of the fuel filter of thin cleaning
5.3. Replacement of a replaceable element of the air filter
5.4. Removal of the case of the air filter
5.5. Removal of the fuel pump on the car with the engine UEPA-331
5.6. Removal of the fuel pump on the car with the VAZ-2106 engine
5.7. Dismantling of the fuel pump
5.8. Removal of the fuel tank and fuel receiver
5.9. Removal of a cable of the drive of butterfly valves of the carburetor
5.10. Removal of a cable of the drive of the air gate of the carburetor
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










5-7-razborka-toplivnogo-nasosa.html

5.7. Dismantling of the fuel pump

To clear it is possible (to replace) the mesh filter and to replace diaphragms, without removing the pump from the engine. (For descriptive reasons we carry out these operations on the dismantled pump of the VAZ-2106 engine.)

Key "on 10" we turn off a bolt of fastening of a cover of the pump.

We uncover and take out the mesh filter.

By the crosswise screw-driver it is turned off six screws connecting top and lower a pump housing...

... also we separate cases.

Having pressed and having turned diaphragm knot on 90 °, we take out it from the lower part of the case and we remove a spring from a rod.

Key "on 8" we turn off a nut of fastening of a rod...

... and consistently we remove: top steel plate, two workers and safety diaphragms, external and internal remote pro-rates, lower plate and washer.

We assemble the pump in the return sequence. At installation of diaphragms we combine their openings with openings of the lower pump housing.

The mesh filter is installed in a pump housing so that its opening settled down over the valve. Otbortovka of an opening of the filter has to enter a valve opening.

The pump of the engine UEPA-331 understands almost similarly except that the cover of the pump fastens to the top case two screws.


"previous page
5.6. Removal of the fuel pump on the car with the VAZ-2106 engine
following page"
5.8. Removal of the fuel tank and fuel receiver