Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
7.1. Description of a design
7.2. Replacement of spark plugs
7.3. Removal of a cover and rotor of the distributor of ignition
7.4. Ignition distributor lubricant
7.5. Adjustment of the moment of ignition
7.6. Check and adjustment of a gap between contacts of the breaker
7.7. Removal of the distributor of ignition
7.8. Dismantling of the distributor of ignition
7.9. Removal of the condenser
7.10. Removal of the vacuum regulator of an advancing of ignition
7.11. Removal of a motionless plate of contact group of the breaker
7.12. Removal of the roller of the distributor
7.13. Removal of the coil of ignition
7.14. Councils of skilled
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










7-7-snyatie-raspredelitelya-zazhiganiya.html

7.7. Removal of the distributor of ignition

We uncover the distributor, without taking out from it high-voltage wires (see. "Removal of a cover and rotor of the distributor of ignition"), also we take a cover aside.

We pick up the phone from the union of the vacuum regulator of an advancing of ignition.

Key "on 7" we turn off a nut of a contact bolt of fastening of a tip of a wire from the ignition coil.

We remove a wire tip.

Key "on 12" we weaken a high nut of fastening of the distributor.

Shaking, we take out the distributor from the distributor drive.

For replacement of a rubber sealing ring of a shaft of the case of the distributor...

... we hook a ring the screw-driver...

... also we remove it.

Before installation of the distributor on the engine we oil a sealing ring engine.

We install the distributor in the return sequence.

At the same time short moustaches of the coupling of the roller of the distributor have to enter a groove of its drive, and the bigger sector of the coupling — to coincide with big sectors of the drive.

We regulate the ignition moment (see. "Adjustment of the moment of ignition")


"previous page
7.6. Check and adjustment of a gap between contacts of the breaker
following page"
7.8. Dismantling of the distributor of ignition