Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
8.1. Description of a design
8.2. Replacement of spark plugs
8.3. Removal of a cover of the distributor of ignition
8.4. Removal of a rotor of the distributor of ignition
8.5. Ignition distributor lubricant
8.6. Adjustment of the moment of ignition
8.7. Check and adjustment of a gap between contacts of the breaker
8.8. Removal of the distributor of ignition
8.9. Dismantling of the distributor of ignition
8.10. Removal of the coil of ignition
8.11. Councils of skilled
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 










8-9-razborka-raspredelitelya-zazhiganiya.html

8.9. Dismantling of the distributor of ignition

We remove the distributor (see. "Removal of the distributor of ignition").

We remove a distributor rotor (see. "Removal of a rotor of the distributor of ignition"). We remove contact group (see. "Check and adjustment of a gap between contacts of the breaker").

The Shlitsevy screw-driver we unscrew the screw of fastening of an arm of the condenser to the distributor case...

... also we remove the condenser.

To thin small beards we beat out a pin of fastening of a maslootrazhatel...

... also we remove from the roller a maslootrazhatel and a washer.

We take out the roller from the distributor case.

Having hooked the thin screw-driver, we remove a lock washer of draft of the vacuum regulator of an advancing of ignition.

By the Shlitsevy screw-driver it is turned off two screws of fastening of the vacuum regulator of an advancing of ignition.

We hook the screw-driver draft of the vacuum regulator...

... also we remove the vacuum regulator.

By the Shlitsevy screw-driver it is turned off two screws of holders of the bearing of a mobile plate of contacts of the breaker.

The screw located from a distributor cover clamp fixed also a tip of a wire of "lot" of contacts of the breaker.

We take out a mobile plate together with the bearing.

We assemble the ignition distributor in the return sequence.


"previous page
8.8. Removal of the distributor of ignition
following page"
8.10. Removal of the coil of ignition